ZIP Intermediate Class Polymer Arresters
Zforce Arresters have mold-on polymer housing for the ultimate seal against moisture ingress
High strength Fiberglass for high fault-withstand design
Integrated Ground Lead Disconnet for fast, reliable operation. Operates in less than 2 seconds at 1 amp and less than 2 cycles at 1,000 amps
Expanding (bust) anchors are made for installation in holes augered by power drillers.
One piece formed anchor with wings and a base.
A retainer on the bottom holds the nut from the forged eye rod (sold separately)
NRS Series Non-metallic Industrial Disconnect Switches
The type "ZIP" intermediate class arresters offer the benefits of polymer housings for system voltages up to 161kV.
The arresters are approxiately 1/5 the weight of the porcelain equivalent.
Handling and installation become much easier tasks. Also, the risk of damage to the housing is reduced compared to porcelain.
Surge Tec® arresters incorporate special features that make them stand above
other Secondary Arresters and Transient Voltage Surge Suppressors (TVSS).
These arresters use a patented (#5,502,612) fault withstand design along with
replacement indication.
The arresters are available in 175 volt, 480 volt and 650 volt AC ratings for
application on system voltages below 650 volts phase to ground and operate at
frequencies between 48 and 62 Hz.
High strength pipe
Rugged helix for diffi cult soils
Lead point “stinger” to facilitate initial penetration and “setting the plumb” Structural steel top base plate with slots for variable bolt hole circles to meet
pole base dimensions
Supplied with high strength bolts to secure pole
Available in 6”, 8”, 10” diameters
Lengths from 5 - 10 ft
Two - sided entrance wiring slots
Torque ratings up to 20,000 ft-lbs
Hot dip galvanized for corrosion protection
Installs in minutes
Reduced total installation costs
Poles can be installed immediately
No building forms, setting rebar and anchor bolts
Installation in all weather conditions
Minimal site cleanup of disturbed soil
Street Light Applications
Cross plate anchors are made for installation in holes augered by power drillers.
One piece plate anchor formed of two structureal members that are ribbed for reinforcement.
A retainer on the bottom holds the nut from the forged eye rod (sold separately)
Back to the Products list
In this section you will find examples of availables products , if the desired product is not available, thank you to contact us for more information.
You can also visit the respective manufacturer Website using the links available to you in each section
Distributor of Electrical Products